VL53L0X multiple sensor integration on atmega2560

[Assassin]

So just give me some hint like in other simar topic I see same problem solved by using official library for arduino in which for every sensor an instance /object of VL53L0X was made but the c library I mentioned I can’t create an object so just give some clue how to progress
Reference

VL53L0X -- maximum sensors on I2C arduino bus

Here is my ArduinoCode I used with ProMini and Nano I could have saved my time by reading this earlier, which should be highlighted I suppose: The sensor’s 7-bit slave address defaults to 0101001b on power-up. It can be changed to any other value by writing one of the device configuration registers, but the new address only applies until the sensor is reset or powered off. I suggest to add this white paper also to the product page #include <Wire.h> #include <VL53L0X.h> //#define XSHUT_pin6 …