I have a Stepper motor driver that is based on the TB6560 device.
I wish to change this to the Pololu DRV8825 Stepper Motor Driver Carrier.
However, the connections are different:
On the TB6560 board, the connections are market:
Stepper Motor: A-, A+, B-, B+
Signal Input: DIR-, CP-
What connectors must I use to connect these to the DRV8825
Hello.
You can find information on the connections for the DRV8825 stepper motor driver carrier under the “Using the driver” section on the product page for the board. The connections A- and A+ probably correspond to A1 and A2, and the B- and B+ probably correspond to B1 and B2. If there is anything that seems unclear or anything you have questions about, please let me know.
- Grant