Hi Jeremy, thanks for your comment, but please clarify me a little more.
Today i receive my https://forum.pololu.com/t/pololu-usb-avr-programmer/6269/1
For example, for attiny85 and 8/16 mhz in 5 volt i think i must connect programmer miso, vdd, sck, mosi, rst, gnd pins directly to a attiny miso, vdd, sck, mosi, rst, gnd pins and also source attiny vdd with 5v externally. It's ok? or please correct to me.
To program and use in 3v3 volt you say i need to configure the target VDD an also you say 'However, two output pins on the ISP cable will program your device with 5V.....You might consider adding a voltage divider on those pins.'. What are the pins you refer?, Could you explicity show me? And for 8/16 mhz and 3.3 volts, how i must to connect the programmer to the attiny85, please could you show me?
Best regards, Pescadito