Using the micro maestro control center to control a micro maestro 6-channel controller, I am compiling a script to control 2 servos and 3 output signals to an LED. I set my target values in the status tab then saved the frames individually. I did this to construct 4 different sequences. I then copied all sequences to script. I had to delete the RETURN command from all the sequence scripting in order to run the script with no errors. I then added the GET_MOVING_STATE command. This all works great, but I need to set different speed, and acceleration values for the different sequences. The following is the values needed per sequence. I need to know the complete commands lines and the locations in the script to add them.
Thank You!forum script.txt (1.25 KB)