Hi
It works at baud rate 9600.
But if I set anything higher… I get the flashing light.
I have to turn off and turn back on again.
Is there anything I should know about in order to set it higher.
I am using my laptop with usb 2.0 winXP sp2
Hitech servo 645MG (analog servo)
I am using Pololu Mode.
As mention 9600 works fine.
But anything doesn:t work.
14400
19200
28000
38400
Thank in advance
Hello,
Which servo controller are you using? Also, make sure you’re not trying to change baud rates after you’ve used one. In general, it would help if you reported more details about what’s going on. For instance, there are at least three LEDs on all our servo controllers, and different LEDs flashing mean different things. Which one is flashing, after which byte that you’ve sent?
- Jan
"Also, make sure you’re not trying to change baud rates after you’ve used one. "
OK, now it works.
The max baud speed I get is 57600.
I have tried anything higher I get flashing red light.
So I guess the max I can do is 57600.
thank Jan for the tips.
