Hi to everybody.
I just got a PStar, but I can’t get this working. I 've followed each step in pololu P star guide to run the assembler test code , but it doesnt run .
I’ ve installed the “p load” aplication and my computer recognize the board and every thing is OK,
i compilled the assembler test code to drive red led using MPLAB X 2.35, after compilating I download the hexfile to the board using comand p-load -w hexfile , again everiting was OK.
I got this message:
Bootloader: Pololu P-Star 25K50 Bootloader
Serial number: 00096942
Erasing flash…
Progress: |##########################################################| Done.
Writing flash…
Progress: |##########################################################| Done.
Erasing EEPROM…
Progress: |##########################################################| Done.
After this the green led at the board continue blinkink as bootloader mode, Itried to plug in and unplug the usb cable
but it is the same, I have tried too cuse a reset with a button from MCLR to GND but it continue without running the aplication.
I hope someone to helpme.
Thankss.