Name:                         Tic 36v4 High-Power Stepper Motor Controller
Serial number:                00384854
Firmware version:             1.08
Last reset:                   Power-on reset
Up time:                      2:02:16

Encoder position:             0
RC pulse width:               N/A
Input state:                  Not ready
Input after averaging:        N/A
Input after hysteresis:       N/A
Input before scaling:         N/A
Input after scaling:          0
Forward limit active:         No
Reverse limit active:         No

VIN voltage:                  23.756 V
Operation state:              Soft error
Energized:                    No
Homing active:                No

Target:                       No target
Current position:             0
Position uncertain:           Yes
Current velocity:             0
Max speed:                    10000000
Starting speed:               0
Max acceleration:             10000000
Max deceleration:             10000000
Acting target position:       0
Time since last step:         4294967295
Step mode:                    Full step
Current limit:                1934 mA

Errors currently stopping the motor:
  - Serial error
  - Command timeout
  - Safe start violation
Errors that occurred since last check:
  - Command timeout
  - Safe start violation
Last motor driver errors: None

SCL pin:
  State:                      Output low
  Analog reading:             N/A
  Digital reading:            1
SDA pin:
  State:                      Output low
  Analog reading:             N/A
  Digital reading:            1
TX pin:
  State:                      Output high
  Analog reading:             N/A
  Digital reading:            1
RX pin:
  State:                      Pulled up
  Analog reading:             N/A
  Digital reading:            1
RC pin:
  Digital reading:            0