Use output for led

Support Servo controllers and servos
1

Hi,

i want to use a channel to let a led shine or not. I tried to use the “Pololu Maestro Control Center”.
But when i switch a channel mode to output the led is shinig everytime. I doesnt matter wether i switch enbaled to on or off.

It is possible to change a LED-status?

Best Regards,
joerg

2

Hello, joerg.

Which pins of the Maestro did you connect the LED to? If you check the “Enabled” checkbox and try moving the slider bar through its full range of motion, can you get the LED to turn off?

–David

3

Hi,

i connect the LED to the these pins: .
Sliding not working.

best regards,
joerg

4

You should instead connect it to the pins indicated in the “Attached Servos and Peripherals” section of the Maestro user’s guide:

–David

5

hi,

looks good … i don’t find this site think it will help.

thanks,
joerg