Micro maestro PCB

I can’t seem to find a schematic for the micro maestro PCB board, could someone please point me towards a link, or email me with a schematic for the PCB? I need to know all the through-hole distances.


Contact us and we can send you a dxf file of the through hole locations. You might also be able to get by with this picture:

The servo header area is on a 0.1" grid offset 50 mils from the edges.

- Ryan

If you want to integrate the Maestro into your own board, you’ll find that the servo grid through holes and the other connectors (Vin, Gnd, Tx, Rx, Rst etc.) do not lie on the same 0.1" grid… (at least for the 12ch Maestro Mini for which I did this).