Micro Maestro and Qik in serial

I have a Netduino Plus. I would like to hook a Micro Maestro 6 channel (part # 1350) and two Qik 2s9v1 (part # 1110) together along one serial line.

I just want to make sure that they would be compatible on the same line. Also, assuming that the Micro Masestro is board #1 how would I tell the two Qik 2s9v1 that they are board #2 and #3.

I am also assuming that this configuration would only use one digital pin of my Netduino for TX to the three boards.

Lastly, is there any code examples for the Qik 2s9v1 for the Netduino?

Thanks, John

After reading through the Maestro pdf manual a second time, I spotted my answer on page 44 where it talks about daisy chaining…(it couldn’t have been more clearer)…

The following diagram shows how to connect one master and many slave devices together into a chain. Each
of the devices may be a Maestro or any other device, such as a jrk [pololu.com/catalog/product/1392],
qik [pololu.com/catalog/product/1110] or other microcontroller.

Thanks, John

Hi, John.

I am glad you found the answer to your question, and thank you for posting it.

- Ryan