Change the servo speed, using micro controller channel 6

Hello everyone, I have a Pololu micro controller 6 channel and would like to know how do you decrease the speed of movement of the servo.
I tried to enter a few commands but the servo move from one point to another too quickly.
How do you change the speed?

Hello.

There are a few ways to set the speed for a given servo channel; they are all described inside Maestro’s user’s guide, which is located under the Resources tab of its product page. If you have a specific question about one of those methods, let me know, and I’ll see if I can help.

By the way, a quick way to set the speed of a servo channel is to use the Speed parameter under the Status tab of the Maestro Control Center.

-Jon