Arduino + G2 18v25

Support Motor controllers/drivers and motors
1

Hi,

I just bought two G2 18v25s. I’ve tried driving a DC motor (12V) with both of them. I can see logic pins being set from Arduino (tested with LEDs), but the motor does not run. Please help.

Thank you

IMG_20170327_154228.jpg3024×4032 1.22 MB
IMG_20170327_154220.jpg3024×4032 1.41 MB
IMG_20170327_153746.jpg4032×3024 4.06 MB
IMG_20170327_154040.jpg3024×4032 3.46 MB

2

Hello,

Since you contacted us directly and found soldering was the issue, we will consider this thread closed. If you need further help, you can post additional questions here; we are glad to help.

-Derrill

3

Hi Derill,

Thank you so much for your help. Yes, this thread can be closed.

Thank you again,
Ajay