16 Servo USB, Flash red led

Hello, I have just written a simple prog to test out my 16 servo usb device. In Mimi SSC II Mode if I send FF 01 60 the red led comes on and start flashing. I can not find any reference to flashing red leds, only sold. I have also tried Plollu Mode, with obviously different number squences, however, I get the same. Any ideas.

John

Cause… USB Port, tried it on another, all worked fine. I would still like to know the meaning of the flashing red led, other than, ‘I’m not well’ :frowning:

Hello,

The flashing red LED indicates a fatal error, and that usually occurs when the incoming serial data has some major flaws in it. For instance, changing the baud rate on the fly will cause the servo controller to fail.

- Jan