Pololu Robotics & Electronics
My account Comments or questions? About Pololu Contact Ordering information Distributors

Support   Sensors

GP2Y0A51SK0F with different resistors in PCB (2)
Reverse line following (5)
Sensor Connection Pattern (4)
How to connect sensoer to follow linw (3)
MinIMU-9 v5 unstable Gyro reading (5)
Altimu 10 v5 (4)
Raspberry pi 3 + altimu 10 V5 (6)
VL53L0X readings are wrong (4)
LSM6DS33 suddenly stopped working (2)
3pi Maze robot Auto-calibration turn off (2)
L3gd20h data ready interrupt (2)
Problems may occur while using qtr8rc for follow a white line (3)
Lsm303d drdy signals (3)
ACS715 Current Sensor Carrier 0 to 30A - +i designation (3)
Calibrating the QTR-8a Twice (3)
GP2Y0D805Z0F as VR Mask Proximity Sensor (2)
Restart pololu VL6180X (3)
VL6180x Startup Issue, when connecting to different boards (3)
miniIMU-9 v3 Calibrating/Gain Value (4)
MinIMU-9 v5 and AHRS questions (11)
QTR-8RC 'Position' Reading when line is below 3 sensors at a time (4)
VL53L0X gives incorrect reading against shiny plastic (6)
TSSP58p38 distance measurement (2)
IR beacon transceiver's Enable Pin (2)
Using QTR-8RC sensor for black and white line following (4)
Magnetic encoder kit disk material (3)
LPS25H. Problems reading output data (5)
ACS715 Current Sensor Carrier 0 to 30A Question (2)
LSM303D from Zumo Shield 1.2 hang in init() (5)
List of commands given on sensor vl53l0x after I2C (2)