Pololu Robotics & Electronics
Menu
My account Comments or questions? About Pololu Contact Ordering information Distributors

Support   Sensors


QTR-8RC vs QTR-8A (2)
VL53L0X goes out range after a 15 to 20 minutes of operation (3)
Question regarding AltIMU-10 v5 (LPS25H Carrier) calibration (2)
Guide me making a line follower (5)
QTR 8RC Analog output problem (3)
Acs711ex (4)
VL53L0X and VL6180X (Multiple) Issues (3)
Line following without calibrating? (2)
Pololu AltIMU-10 v4 Raw Data Conversion (4)
VL53L0X -- maximum sensors on I2C arduino bus (19)
AltIMU-10 v5 roll pitch yaw values (2)
Advice and documentation about QTR-8A (2)
ACS714 separation (3)
Zumo Reflectance Sensor Array not working (5)
VL53L0X sensor on stm32 nucleo l4xx (3)
L3g20h gyroscope code getting stuck (13)
Problem reading two MinIMU-9 v5 with Arduino Due via I2C (5)
Sensor software advice for Minimu-9-AHRS test (7)
Atmel Studio 7 with QTR8A compile error (5)
Linux sensor data, A STAR 32U4 Prime SV w/accel/gyro/magnetometer board (20)
Help with line follower using QTR8-RC (2)
Narrowing VL53L0X beam width mechanically? (2)
LSM303D - Device identification register not correct and ACC/MAG values not changing even though I2C is working (8)
Help with Pololu QTR-8RC sensor, please! (4)
QTR-8RC unique calibration (3)
VL53L0X Long-Range Range Profile (4)
LSM6DS33 - Raw values raspberry pi (2)
VL53L0X - Multiple Sensors (2)
Connecting three GP2Y0A21YK0F with 3pi expansion set (5)
Barametric readings off for LPS25H (7)