Pololu Robotics & Electronics
Menu
My account Comments or questions? About Pololu Contact Ordering information Distributors

Support   Motor controllers/drivers and motors


How do I implement a home Limit Switch with a Tic Stepper? (4)
MP6500 - measure Vref on pot or just at via? (3)
Verifying safe motor control and gear motor compatibility? (3)
Problem driving a Peltier (TEC) module with low voltage vIN (0.8v) (4)
Drive a step motor 3.1V /2.5A (2)
Motor shield and pwm (2)
Dual VNH5019 shield in single-channel mode strange problem (3)
Setting Current Limit on DRV8825 (md20a) with #1206 Stepper (12)
Clamp diodes Jrk G2 (4)
Pololu Dual VNH5019 and Labview (4)
Micro motor with screw shaft (2)
Can’t Get A4988 Stepper Motor Driver to Work using Arduino (19)
Do you carry a motor driver that is a plug and play replacement for the L298N motor driver card but rated at 30A? (2)
Changing the DRV8824 microstep mode in real time (3)
Depth of M3 screws on 25D gearmotors? (3)
MD01B (VNH2SP30) single Motor Controller (3)
Using L298 logic motor diver for 37D motors (2)
A4988 Motor Supply Source Voltage Rating (8)
A4990 stuck in fault state (5)
Strong and fast (2)
Controlling 20 motor (Pololu G2 High-Power Motor Driver) (4)
Arduino Syntax for tic commands (3)
Motor controller caught fire! (2)
Smooth actuation with DRV8880 (2)
TIC T825: Fixed Speed and Position Control (2)
TB6612FNG Vm and Vcc shorted? (4)
Nema 14 and A4988 (4)
Step motor control 90 degrees left and right using a4988? (2)
Related to Micrometal Gearmotors (11)
Raspberry Pi with DRV8835 Motor Kit - Add more components? (4)