I hooked up the supply voltage at 3.3v, connected the outputs to the meastros analog inputs and set the channels in the controller software to be inputs.
All I get is a tiny variation at about 0.01v on the output pins even when I’m rotating the board.
I left the selft test and g select disconnected.
I figure I could use the self test feature to test this Im right in thinking I can just hook that up to the input voltage?
I noticed on your order history that you purchased the smaller version of the MMA7341L accelerometer that does not have a voltage regulator. Have you accounted for the sleep pin on this version of the board? This pin must be driven high, otherwise the board is still in a low-power sleep mode.