Hello everyone,
Problem:
one servo (i00800 with 21v3 jrk)
two (switched) analog input signals:
Encoder : 0-5v (0-10v but with a voltage-divider)
Potmeter: 0-1,7v (I am only using a small part of the 270 degree range)
This setup is chosen to be able to switch between automated input, or manual input. But without constantly configuring the jrk, how am I going to make this work?
I was told that I could use a rail-to-rail OpAmp circuit, but that would require a bipolar power supply, and I don’t want to use that(goal is to keep everything simple).
What would you guys suggest?
Thanks,
Lodi