Hello.
I have just started a new proyect and need some help. It´s about Pololu Zumo robot and a five pin ultrasonic sensor.
I don´t know how to connect it (ultrasonic sensor )to Zumo and arduino so it can avoid obstacules.
Any idea of where i could solder it or connect it? (also will be very usefull a sketch)
I know it´s a dificult question.
Thanks
Since you didn’t tell us what kind of a sensor you have, how would we know how to connect it to anything?
Sorry, you are right.
Ultrasonic sensor HY-SRF05
I also have Sharp GP2Y0A21YK sensor.
I don’t know wich one is better for the project.
Zumo Robot version is the complete kit with reflectance sensor
SRS
5
I would personally avoid soldering anything to the board except pin headers.
(the compass jumper with a DIP Uno being the only exception.)