Hi,
I am in need of a GUI for my Orangutan SVP-1284 and have been trying LabVIEW, but seem to be hitting a brick wall. Does anyone know what drivers I need (I already have NI-VISA) or what steps I need to take to use LabVIEW? Or is this impossible?
If LabVIEW will not work, or there is an easier program to use for this, what should I use?
A bit about the GUI I am making: it needs to bring in data from a pressure sensor, temperature sensor, and a calculated speed from a motor function coded onto the board. It will also need to send a signal to the board if one of six buttons is pressed on the GUI.
Thanks in advance!